HAY BALE-ELEVATOR SYSTEMS
Begin with basic elevator... and custom make a bale handling system to fit your specific needs... all at a surprisingly low cost! Basic elevator includes a drive unit, plus an end section with sprocket and chain tightener. Basic elevator can be easily lengthened by adding inter-changeable long and short center extensions.
Order motor and motor pulley separately.
Need An Accessory?
A complete line of accessories are available to make storing bales a smooth, quick and simple one-man operation.
Extra Heavy Duty
Standard
High-strength 1" square tubing — 70% more flexural strength than comparable round tubing
✔
✔
Heavier design — use as inclined conveyor, mow conveyor or both
✔
✔
Thick-walled 18 ga. steel construction
✔
Thicker-walled 15 ga. steel construction
✔
'Bridge Truss' side reinforcements along full length of elevator prevent sagging, bowing, twisting, and bending. Inclined elevators are self supporting up to 54'
✔
Higher side rails allow bales to sit down deep in elevator (preventing irregular shaped bales from tumbling out)
✔
Extra heavy-duty No.62 conveyor chain equipped with raised links every 24" for more positive movement
✔
Heavy-duty No. 55 conveyor chain equipped with raised links every 24" for more positive movement
✔
Bronze, pillow-block bearings on drive unit — self-aligning with grease zerks
✔
✔
Full 1" solid head and jack shafts
✔
✔
Permanently-lubricated, sealed ball-bearing idler sprockets
✔
Greaseable, bronze-bushing idler sprockets
✔
Stronger No. 40 roller-chain final drive
✔
✔
All electrically wire-welded construction — welds go all the way around seams for added strength
✔
✔
Sturdy, universal motor mount for electric motor is adjustable for leveling, belt take-up and "stop and go" operation. Mount is quickly detachable for inside storage of motor (drive belt included)
✔
✔
Powder-coated bright-red finish... for longer life
✔
✔
